Reinzosil 70 ml Tube – anthracite coloured, solvent-free sealing, adhesive & coating compound based on silicone. Once completely bonded, REINZOSIL is virtually odorless.
This highly elastic universal sealing compound is resistant to mineral oils and numerous synthetic oils, lubricants, petrol, diesel oil, greases, hot and cold water, detergents, sunlight, ozone, and sea water. Suitable for continuous operation in the temperature range between -50 °C and +250 °C (briefly up to 300 °C). Hardness is in the range of 30 to 35 Shore A.
Can be used as FIPG (formed-in-place gasket) for wet assembly, i.e. for sealing small gaps under pressure as well as for cylinder liners in piston machines, and also to compensate for extensive component warping. Moreover, the compound is also used to seal constructional fissures or cracks, and for seals that are subjected to considerable relative movement.
Instructions for use:
- Remove any gasket remnants or other residues such as grease, oil, etc. with RE-MOVE solvent remover.
- Allow the surfaces to dry, then apply the sealing compound on one side.
- Assemble the components immediately.
Processing temperature lies between +5 °C and +40 °C. Depending on temperature and humidity, a skin develops after 5 to 12 minutes. The full curing time depends mainly on the relative air humidity (RH) and room temperature, as well as on the thickness (gap height) and width of the applied layer.
Example: with a layer or gap width of e.g. 7 mm, and a thickness or gap height of 1,5 mm at normal ambient conditions (approx. 23 °C and 50 % RH), curing time would be about 100 hours. Fully cured (vulcanized) material can only be removed mechanically.
Please ensure good room ventilation when using this product.